A control valve is selected around the process duty, not only the pipeline diameter. Complete operating data makes it possible to review capacity, valve travel, pressure drop, materials, operating stability and actuation before a quotation or drawing is confirmed.
1. Process data required for control valve sizing
| Input | Purpose |
|---|---|
| Medium and condition | Identifies liquid, gas, steam or slurry service and supports material and trim review. |
| Minimum, normal and maximum flow | Defines the controllable operating range rather than a single design point. |
| Inlet/outlet pressure and temperature | Establishes available differential pressure and checks service limits. |
| Line size and connection | Confirms piping integration, flange standard and installation arrangement. |
| Control objective | Clarifies flow, pressure, level or temperature control plus accuracy and response expectations. |
2. Valve body, trim and flow characteristic
Globe control valve
Often specified for throttling service where the body, trim, seat leakage class and flow characteristic are selected for the process duty.
Butterfly or ball control valve
May be configured for modulating duty when rangeability, torque, pressure, material and control requirements are evaluated together.
Trim and materials
Review body, plug, seat, shaft, sealing and packing materials against the medium, pressure, temperature and corrosion conditions.
3. Actuator and positioner requirements
For pneumatic control valves, identify air supply, actuator type, required fail position, positioner signal and accessories. For electric control valves, state supply voltage, modulation signal, feedback, torque or thrust requirement, duty cycle and manual override. The final configuration should be confirmed against the selected valve and service conditions.
4. Questions to resolve before order
- Is the valve regulating, isolating or both?
- Are minimum and maximum process conditions available?
- Are there concerns about noise, flashing, cavitation or high velocity?
- What test, inspection, drawing and certification documents are required?
- What control signal, feedback, fail action and delivery schedule apply?
Need a control valve recommendation?
Review our control valve category, then send process conditions through the contact form. For actuator selection, see the control valve actuator guide.
Request technical support